Resumen

OLIVEIRA, Karla M.C; LANCELLOTTI, Ailla C.R.A; CCAHUANA-VASQUEZ, Renzo A  y  CONSANI, Simonides. Shrinkage stress and degree of conversion of a dental composite submitted to different photoactivation protocols. Acta odontol. latinoam. [online]. 2012, vol.25, n.1, pp.114-121. ISSN 1852-4834.

The aim of this study was to evaluate the polymerization stress and degree of conversion of a composite submitted to different photoactivation protocols. The composite Filtek Z350 was placed in the central perforation of a photoelastic disc and polymerized using a LED-based curing unit (BluePhase II - IvoclarVivadent) with energy density of 12, 24 or 36 J/cm² using the following photopolymerization protocols: continuous high intensity (HI: 1200 mW/cm² during 10, 20 or 30s), continuous low intensity (LI: 650 mW/cm² during 18, 36 or 54s) and soft-start (SS: 150 mW/cm² during 5 s + 1200 mW/cm² during 9, 19 or 29s) (n=5). Photoelastic analysis was used to evaluate polymerization shrinkage stress and FTIR was performed to determine the degree of conversion of the composite. ANOVA 3-way procedure was used to determine the significance of the main effects and their interactions followed by two-way ANOVA for each time was performed (p<0.05). Shrinkage stress increased with higher values of energy. No statistically significant differences on polymerization shrinkage stress were found between high and low intensity activation modes. Softstart method generated stresses that were statistically lower than continuous modes except when 12 J/cm² was applied. Similar degree of conversion was observed for photoactivation modes used, except for soft-start mode with 12, 24 and 36 J/cm² that showed lowest levels of conversion. Energy density and activation mode influenced polymerization shrinkage stress, but no benefit on degree of conversion was observed.

Palabras clave : Composite resins; Dental stress analysis; Polymerization.

        · resumen en Portugués     · texto en Inglés     · Inglés ( pdf )